10
HEATING- QUICK START & STOP
Getting Started
(Quick-Start & Stop Continued Next Page)
1. Verify Electrical Power is Present at Heater:
A. Ensure that the unit has electrical power connected; the heater controller display should
be illuminated;
B. If the display is blank, be certain the electrical breaker, and heater disconnect, are
switched to “ON”;
C. For now, leave the water circulation pump OFF.
A. The owner settings can be set without water flowing. Once the heater has electrical power
connected, with water not flowing, the display should read FLO;
B. Press the MODE button until the HEAT (HEA) indication displays. This action will enable
the remaining programming keys;
C. Using the POOL / SPA selector key, select the POOL mode. The chosen mode will be
verified by an illuminated indicator light, located on the left side of the display, showing
that the POOL control has been selected (If heating just a spa, using the DOWN arrow
key, lower the POOL temperature until OFF is displayed; then proceed to Step-E. ).
D. Use the UP / DOWN arrow keys to set the desired water temperature for the POOL water;
E. If the heat pump will be used to heat a spa, use the POOL/SPA selector key to select
SPA, then use the UP / DOWN arrow keys to set the desired water temperature for the
SPA (If heating just a POOL, using the DOWN arrow key, lower the SPA temperature until
OFF is displayed.);
F. The heat pump controls are now set to maintain the desired water temperature for the
POOL and/or SPA.
2. Set the Heater Controls (Refer to Control Panel Layout, Pg-12):
OWNER- If heater is connected to a Call-Flex controller, also see Call-Flex programming
located in
Owner Level Programming, beginning on page-14 of this manual.
INSTALLER- Is heater connected to an external controller? See:
Dealer-Specific Instructions,
beginning on page-31 this manual.
This brief information is provided as an aide to installers, service personnel, and owners. The intent of
this section is to provide rapid access to (only) very basic operational information. Individuals who will
be routinely using, installing, maintaining, and servicing this heat pump, are strongly encouraged to
read this entire manual. Herein, the terms: Heat Pump, Heater, and Unit are used synonymously.
These instructions are intended for local control of a heat pump, independent of an external
controller. Owners: if your installation includes an external controller, contact your installing
dealer for operational instructions.
These are instructions to quick-start in the HEATING mode...Owners of Heat-Cool units, in order to
utilize all features of their heater, will certainly want to also refer to:
Owner Level Programming, begin-
ning on page-14 of this manual.
