A SERVICE OF

logo

Open as PDF
next previous
www.aleratec.com
7
Disc Buffing Procedure
TheDiscBufngprocedureisintendedforthemostseverelydamaged
discs. This process, which removes a small amount of plastic from the disc,
allows deeper levels of damage to be repaired.
RemovethepinkBufngunitsfromtheproductpackaging.1.
Note: Buffing heads must be mounted onto clear
plastic bases prior to use. Use the plastic end of the
brush tool to pry each of the two Repair heads into its
base. Install each Buffing head onto a base, pressing
down gently until they snap into place.
InstalltheassembledBufngheadsintothemotorized2.
repair unit and rotate counter-clockwise to secure them.
Insert the disc (data-side facing downward) and close the 3.
top cover.
PresstheREPAIRbuttontobegintheBufngprocess.4.
It will run for approximately two minutes and stop
automatically when complete.
Press the OPEN button to remove the disc, then follow 5.
with the Disc Repair Procedure (see page 6) to create a
protective layer on your disc.