43
| Page © Adam Equipment Company 2009
When [Setup/Enter] is pressed and passcodes are not enabled the display
will show the first section of the menus, Serial interface. If passcodes are
enabled, the analyzer will ask for it by displaying :
With the right digit flashing.
Enter the correct passcode using the numeric entry method.
If a wrong code is entered the analyzer will return to weighing mode
If the passcode has been enabled and entered, the analyzer will allow the
operator to access the Supervisor’s menus
The [Dspl] and [Test] keys will cycle through the main headings, pressing
the [Setup/Enter] key will enter the heading and sub-parameters or options
can be set. Press [PST]
to come out of a sub-menu and go up one level or
[Esc] to return to normal weighing from any menu
PASSCODE
000000
