Filter
Top Products
11
CONTRAST
The Contrast setting allows you to modify the optical
characteristic of the display.
Example:
1. Enter the Menu option and select the Contrast
setting.
2. Use the Change button to set up the desired
contrast level.
BRIGHTNESS
The Brightness setting allows you to modify the
backlight intensity of the display.
Example:
1. Enter the Menu option and select the Brightness
setting.
2. Use the Change button to set up the desired
brightness level.
Note:
At the end of the programme if no button is pressed for
approximately 10 minutes the backlight intensity goes off.
7 START/PAUSE button
This button has 2 functions:
Start/
Pause
Change
Options
Exit
Brightness
B
Temp. Spin
Change
Options
Exit
Brightness
A
Temp. Spin
Change
Options
Exit
Contrast
B
Temp. Spin
Change
Options
Exit
Contrast
A
Temp. Spin
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light close to the button will stop
flashing and remain lit.
If you have selected a delay time option, the countdown
will begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light close
to the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, it becomes possible to
open the door if:
• The washing machine is not in the heating phase;
• The level of the water is not high;
• The drum is not turning.
Important!
You must set the washing machine to PAUSE before
you make any change in the programme in progress.
8 Vocal messages
An electronic vocal board helps you throughout the wash
process, with its clear, simple and helpful messages.
The vocal messages can be activated or deactivated by
simultaneously pressing the buttons Change and Exit.
To confirm the voice setting, the display will show
either “Voice Enable” or “Voice Disable”.
There are three possible volume settings (MIN, MED
and MAX).
To select required level, press repeatedly the Options
button until the symbol flashes, then press the
buttons Change and Options until the required volume
is displayed. Press finally the button Exit to confirm the
selection. (see page 9)
When the appliance is switched on, a friendly jingle can
be heard.
There are two kinds of message:
● A message to explain how to set up a washing
programme, and to describe the different options.
The message will be heard a few seconds after a
selection has been entered.
● warning message.
These messages will sound repeatedly until the cause
has been corrected.