Filter
Top Products
22 technical specifications / installation
Drainage
- The connector at
the end of the flexi-
ble hose can be at-
tached to all
common types of
standpipe.
Attach the connec-
tor to the standpipe
with the hose clamp supplied with the
appliance
*
.
- Fit the U-piece on
the drainage hose.
Place everything in
a drainage point (or
in a sink) at a height
of between 70 and
100 cm. Ensure it is
positioned secu-
rely. Air must be able to enter the end of
the hose, to avoid any risk of siphoning.
The drain hose must never be stretched.
If it is too short, contact a tradesperson.
Electrical connection
This washing machine must only be
connected in single-phased 230 V.
Check the fuse size : 10 A for 230 V.
The appliance must not be connected
with an extension lead or multi-plug
adaptor.
Ensure that the plug is earthed and that
it is in accordance with current norms.
Positioning
Position the appliance on a flat and hard
surface in a ventilated location. Ensure
the appliance does not come into con-
tact with the wall or other furniture.
To move the appliance, proceed as fol-
lows :
To move your ap-
pliance, place it on
its rollers by pulling
the lever located at
the base of the ap-
pliance hard from
right to left. Once
the appliance is in
the desired position, push the lever back
to its original position.
Accurate levelling avoids vibrations, noi-
se and prevents the appliance from mo-
ving when running.
* depending on model
1
2
1
2
3