Zanussi ZWT 10120 Washer User Manual


 
18 operating problems
Wash is unsatisfactory : the detergent is unsuitable for machine
washing,
there is too much washing in the drum,
the wash cycle is unsuitable,
there isn’t enough detergent.
The appliance vibrates, is
noisy :
• the appliance hasn’t been untied properly (see
untying section),
the appliance isn’t level and is unbalanced,
the appliance is too close to the wall or furni-
ture,
washing is unevenly distributed in the drum,
the load is too small.
the wash cycle is much too
long :
the water inlet filters are dirty,
the power or water supply has been cut off,
the motor overheating detector has been acti-
vated,
the water inlet temperature is lower than usual,
the foam detection security system has been
activated (too much detergent) and the washing
machine has begun draining the foam,
the out of balance detector has been activated :
an extra phase has been added to distribute
washing more evenly in the drum.
The washing machine
stops during a wash cycle :
the water or electricity supply is defective
a Rinse hold has been selected,
the drum shutters are open.
The lid doesn’t open at the
end of the cycle :
the “immediate opening”
*
light is not lit,
the temperature inside the drum is too high,
the lid unlocks 1 - 2 minutes after the end of the
cycle*.
The “open drum” light is not
on at the end of the cycle :
• the drum could not stop in the correct position
following an unbalanced spin cycle; turn drum
manually.
The “Start/Pause”
pushbutton
**
flashes red
***
:
the lid isn’t closed properly.
Problems Causes