Zanussi ZWT 10120 Washer User Manual


 
operating problems 17
Operating problems
Numerous checks were carried out on your appliance before it left the factory.
However, should you notice a malfunction, please refer to the sections below before
contacting the after-sales service.
Problems Causes
The washing machine
doesn’t start or doesn’t fill :
the appliance isn’t plugged in correctly, the
electrical installation isn’t working,
the lid of your appliance and the drum shutters
aren’t closed firmly,
the programme start command hasn’t been
properly selected,
there is a power failure,
the water supply has been cut off,
the water inlet tap is closed,
the water inlet filters are dirty,
a red tab appears on the water inlet hose.
The appliance fills but
empties straight away :
the drainage U-piece is fixed too low (see instal-
lation section).
The washing machine
doesn’t rinse or doesn’t
empty :
the drain hose is blocked or bent,
the drainage filter is obstructed,
the out of balance detector has been activated :
washing is unevenly distributed in the drum,
the “Drain” programme or “Night Silence Plus”
option have been selected,
the height of the drainage U-piece is unsuitable.
You have found water
around the washing
machine :
• too much detergent has caused foam to over-
flow,
the detergent is unsuitable for machine
washing,
the drainage U-piece isn’t attached correctly,
the drainage filter hasn’t been put back in
place,
the water inlet hose is leaking.