Filter
Top Products
The other end of the inlet hose which connects
to the appliance can be turned as showed in the
picture.
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap. Set the hose cor-
rectly by loosening the ring nut. After position-
ing the inlet hose, be sure to tighten the ring
nut again to prevent leaks.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the edge
of a sink using the plas-
tic hose guide sup-
plied with the ma-
chine.
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch . This branch must be
above the trap so that the bend is at least 60
cm above the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm. The end
of the drain hose must always be ventilated ,
i.e. the inside diameter of the drain pipe must
be larger than the outside diameter of the drain
hose. The drain hose must not be kinked.
Electrical connection
Information on the electrical connection is given
on the rating plate on the inner edge of the ap-
pliance door.
Check that your domestic electrical installation
can take the maximum load required, also taking
into account any other appliances in use.
Caution! Connect the machine to an
earthed socket.
Caution! The manufacturer does not accept
any responsibility for damage or injury through
failure to comply with the above safety
precaution.
Caution! The power supply cable must be
easily accessible after installing the machine.
Caution! Should the appliance power
supply cable need to be replaced, this must
be carried out by a Service Centre.
Environment concerns
The symbol on the product or on its
packaging indicates that this product may not be
treated as household waste. Instead it should be
taken to the appropriate collection point for the
recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly,
20