Filter
Top Products
The filter is inserted correctly when the indicator on
its top is visible and blocked.
• close the filter cover;
• insert the mains plug
again.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, it takes a long
time to fill with water, the starting button flashes red or
the display (if available) shows the relevant alarm (see
chapter "What to do if..." for more details), check if the
water inlet filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose
from the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose
from the appliance.
Keep a towel nearby be-
cause some water may
flow.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back to the appliance and make
sure the connection is tight.
• Turn on the water tap.
What to do if…
The appliance does not start or stops during operation.
Certain problems are due to lack of simple maintenance
or oversights, which can be solved with the help of the
indications described in the charts, without calling out
an engineer.
During appliance operation it is possible that the red pi-
lot light of the button 6 flashes and one of the indicator
pilot lights illuminates to indicate that the appliance is
not working.
Before contacting your local Service Centre, please car-
ry out the checks listed below.
21