Zanussi ZWF 1632 W Washer User Manual


 
1 “On/Off” button
Press this button to switch the washing machine on.
Press the On/Off button again to switch the machine
off.
2 MAINS-ON light
This light is connected to the “On/Off” button. It lights
up when you press the button, and goes out when you
press it again.
3 “Fabrics” button
Press this button repeatedly to select the programme on
the basis of the type of laundry to be washed. The light
relevant to the selected programme will light up. The
washing machine will propose a temperature and
automatically select the maximum spin value provided
for the programme you have chosen. You can change
these values by operating buttons 4 and 5.
4 “Temp.” button
Press this button repeatedly to increase or decrease the
temperature, if you want your laundry to be washed at a
temperature different from the one proposed by the
washing machine. The relevant light will light up.
Maximum temperatures are 95°C for cotton, 60°C for
synthetic fabrics, 40°C for delicate fabrics and wool.
6
The Control Panel
123456 789
900
700
500
Delicates
60°C
50°C
95°C
40°C
Prewash
30°C
Wool
On/Off
Cottons
Synthetics
Temp.
Spin
Skip
Start/
Pause
Rinse Hold
Reset
ZWF
1432 W
Prewash
Wash
Rinse
Rinse Hold
Spin
Drain
Filter
End
1400
Fabrics
Option
Half
Load
40° AA
5 “Spin” button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed different
from the one proposed by the washing machine. The
relevant light will light up.
Maximum speeds are:
for cotton:
1,400 rpm for Models ZWF 1432 W and ZWF 1432 S;
1,600 rpm for Model ZWF 1632 W
for synthetic fabrics and wool: 900 rpm;
for delicate fabrics: 700 rpm.
• “Rinse Hold” position:
when you choose this option, the machine will not drain
the water of the last rinse, so as not to crease the
laundry.
At the end of the cycle, the light of the “Start/Pause
button goes out, the “End” and “Rinse Hold” pilot
lights illuminate and the door is locked to indicate that
the water must be drained.
IMPORTANT!
By pressing the “Temp.” and “Spin” buttons
simultaneously for about 3 seconds, the acoustic
signal is deactivated at the end of the cycle, when
selecting the programmes and in case of an incorrect
option selection .
By pressing these 2 buttons again the acoustic signal
is reactivated.
ZWF 1432 W
Ofrecido por www.electromanuales.com