Filter
Top Products
11
12. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washing machine, the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the “On/Off” button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the “On/Off” button
again, the washing machine will resume the programme
from the point where it had been interrupted.
13. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, the
“Start/Pause” button light goes off and the “End” light
illuminates.
If you have selected the “Rinse Hold” option, the door
is locked, the Start/Pause button light goes off, the
“End” pilot light illuminates and the Rinse Hold pilot
light remains lit to indicate that the water must be
drained.
To complete the cycle, press “Skip Reset” button once,
all the leds are off, then choose one of the following
options:
• Drain only: press FABRIC button in order to select
the desired programme and press the “Skip Reset”
button until the only led “Drain” illuminates.
Depress “Start/Pause” button
• Drain and Spin: press FABRIC button in order to
select the the previously selected programme (the type
of fabric just washed) and press the “Skip Reset”
button until the only led “Spin” illuminates.
You can change the spin speed by means of “Spin”
button if needed, then depress “Start/Pause” button.
When the programme has been completed, an audible
signal is given.
Press the Skip Reset button repeatedly to erase the
programme that has just been carried out. If you
omit to do this, the next time you switch the washing
machine on, you will hear an audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the FABRIC button and select a new
programme.
Press the “On/Off” button to switch the machine off.
The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.
Ofrecido por www.electromanuales.com