Filter
Top Products
16
Heating phase
During the washing
cycle the display shows
a temperature icon to
indicate that the
appliance has started
the heating phase of the water in the tub.
Start the programme by pressing the button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
The «Wash» and «Door» lights illuminate to
indicate that the appliance starts operating and
the door is locked.
To interrupt a programme which is running,
press the button : the corresponding green
pilot light starts to flash. To restart the
programme from the point at which it was
interrupted, press this button again.
If you have chosen a delayed start, the
machine will begin the countdown.
IMPORTANT!
If an incorrect option is selected, the red pilot
light of this button flashes 3 times and the
message Err is displayed for a few seconds.
Select the Delay Start by pressing the
button
Before you start the programme, if you wish to
delay the start, press the button repeatedly,
to select the desired delay.
The selected delay time value (up to 20 hours)
will appear on the display for a few seconds,
then the duration of the programme will appear
again.
You must select this option after you have set
the programme and before you press the
button .
6
7
7
6
6
2.05
Selecting the delayed start:
● Select the programme and the required
options.
● Select the delay start by pressing the button
.
● Press the button : the machine starts its
countdown.
The programme will start after the selected
delay has expired.
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the button .
If you have already pressed it, and you wish to
cancel the delay time, proceed as follows:
• set the washing machine to PAUSE by
pressing the button ;
• press the button repeatedly until the
symbol 0’ is displayed.
• press the button again to start the
programme.
IMPORTANT!
• The selected delay can be changed only
after selecting the washing programme
again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button and then wait a few
minutes until the «Door» light has gone off.
After you have closed the door, press the
button again.
The Delay Start cannot be selected with
Drain programme.
Indicator lights ( )
After having pressed the button , the
«Wash» pilot light illuminates and stays on
while the machine is working. At the end of
any cycle it goes off.
6
8
6
6
6
7
6
6
6
7
Operating sequence
132962510.qxd 01/07/2008 10.04 Pagina 16