Filter
Top Products
15
Operating sequence
Select the desired option by pressing the
button
Press this button repeatedly, to select one of
the available options. The relevant light will
light up.
Prewash: select this option if you wish your
laundry to be prewashed at 30°C before the
main wash. The prewash ends with a short
spin in programmes for cotton and synthetic
fabrics, whereas in the programmes for
delicate fabrics the water is only drained.
Intensive: this option can be selected for
heavily soiled laundry: the washing intensity
will be increased and the washing time will be
prolonged by a few minutes depending on the
selected type of fabric.
Super Quick: a very short cycle for slightly
soiled items that have been used or worn for a
short time.
The washing time will be reduced according to
the type of fabric and the selected temperature.
We recommended that you to reduce the
laundry load (see the programmes table).
Select the Extra Rinse option by pressing
the button
The machine performs some additional rinses.
This option is recommended for people who
are allergic to detergents, and in areas where
the water is very soft.
Display ( )
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is
displayed in hours and minutes (for example
2.05). The duration is calculated automatically
on the basis of the maximum recommended
load for each type of fabric.
5
4
3
After the programme
has started, the time
remaining is updated
every minute.
Delayed start
The selected delay (20 hours max) set by
pressing the relevant button appears on the
display for about 3 seconds, then the duration
of the previously selected programme is
displayed.
The delay time value
decreases by one unit
every hour and then,
when 1 hour remains,
the time decreases
every minute.
Incorrect option selection
If an option which is not
compatible with the set
wash programme is
selected, the message
Err is displayed for a
few seconds and the red
light of the button starts flashing.
Alarm codes
In the event of operating
problems, some alarm
codes can be displayed,
for example E20 (see
paragraph “What do
if...”).
E20
6
15 h
2.05
132962510.qxd 01/07/2008 10.04 Pagina 15