Zanussi ZWF 14080 W Washer User Manual


 
3
Safety information
In the interest of your safety and to ensure
the correct use, before installing and first
using the appliance, read this user manual
carefully, including its hints and warnings.
To avoid unnecessary mistakes and
accidents, it is important to ensure that all
people using the appliance are thoroughly
familiar with its operation and safety
features. Save these instructions and make
sure that they remain with the appliance if it
is moved or sold, so that everyone using it
through its life will be properly informed on
appliance use and safety.
General safety
It is dangerous to alter the specifications or
attempt to modify this product in any way.
During high temperature wash programmes
the door glass may get hot. Do not touch it!
Make sure that small pets do not climb into
the drum. To avoid this, please check into
the drum before using.
Any objects such as coins, safety pins, nails,
screws, stones or any other hard, sharp
material can cause extensive damage and
must not be placed into the machine.
Only use the advised quantities of fabric
softener and detergent. Damage to the fabric
can ensue if you over-fill. Refer to the
manufacturer’s recommendations of
quantities.
Wash small items such as socks, laces,
washable belts etc in a washing bag or
pillow case as it is possible for such items to
slip down between the tub and the inner
drum.
Do not use your washing machine to wash
articles with whalebones, material without
hems or torn material.
Always unplug the appliance and turn off the
water supply after use.
Under no circumstances should you attempt
to repair the machine yourself. Repairs
carried out by inexperienced persons may
cause injury or serious malfunctioning.
Contact your local Service Centre. Always
insist on genuine spare parts.
Installation
This appliance is heavy. Care should be
taken when moving it.
When unpacking the appliance, check that it
is not damaged. If in doubt, do not use it and
contact the Service Centre.
All packing and transit bolts must be
removed before use. Serious damage can
occur to the product and to property if this is
not adhered to. See relevant section in the
user manual.
After having installed the appliance, check
that it is not standing on the inlet and drain
hose and the worktop is not obstructing the
electrical supply cable.
If the machine is situated on a carpeted floor,
please adjust the feet in order to allow air to
circulate freely under the appliance.
Always be sure, that there is no water
leakage from hoses and their connections
after the installation.
If the appliance is installed in a location
subject to frost, please read the «dangers of
freezing» chapter.
Any plumbing work required to install this
appliance should be carried out by a
qualified plumber or competent person.
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
132963610.qxd 29/04/2008 9.13 Pagina 3