16
Altering an option or a running programme
It is possible to change some options before
the programme carries it out. Before you make
any change, you must pause the washing
machine by pressing the button .
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «Off» and then to the new
programme position. Start the new programme
by pressing the button again. The washing
water in the tub will not be emptied out.
Interrupting a programme
Press the button to interrupt a programme
which is running, the corresponding light starts
to flash. Press this button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. You can now
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button . The light flashes and after a
few minutes, the door can be opened. If it
remains lit, this means that the machine is
already heating, that the water level is too high.
In this case the door can not be opened.
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to «Off».
After a few minutes the door can be opened
(pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button .
5
6.2
5
5
5
5
At the end of the programme
The machine stops automatically.
If the «Rinse Hold» or «Night Cycle» option
has been selected, the door remains locked to
indicate that the water must be emptied out
before opening the door.
To empty out the water proceed as follows:
1.turn the programme selector dial to «Off»
2.select the Drain or Spin programme
3.reduce the spin speed if needed, by pressing
the relevant button
4.press the button
to start the selected
programme
5.at the end of programme, only the light
illuminates. Now it is possible to open the
door.
Turn the programme selector dial to «Off» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
6.3
5
132963610.qxd 29/04/2008 9.13 Pagina 16