Zanussi ZWF 1111 W Washer User Manual


 
8
Important!
The first time you use the washing machine, when
you switch it on, it may display a flashing zero and give
an audible warning signal. This is due to the fact that the
washing machine has performed a washing cycle during
the manufacturer’s inspection tests, and this cycle has
not been erased after its completion.
Delay start, a time value indicated in hours and
selected by means of the relevant button (max 23
hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the “Start/Pause” button, the
countdown begins, and the delay time value decreases
by one unit every hour and then, when 2 hours remain,
the time decreases in 30 minute intervals.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
0
The incorrect selection is also indicated by an audible
warning signal.
An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 20).
8 “Delay Time” button
This button makes it possible to delay the starting of the
programme selected from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the Start/Pause button.
If you have already pressed the Start/Pause button, and
you wish to cancel the delay time, proceed as follows:
• set the washing machine to Pause by pressing the
Start/Pause” button;
• press the “Delay Time” button until the display shows
the symbol «
00
».
• press the “Start/Pause” button again.
Important!
The door will be locked throughout the delay time (the
Door” light will be on).
If you need to open the door, you must first set the
washing machine to Pause by pressing the
Start/Pause” button. The “Door” light goes off and
the door can be opened.
After you have closed the door, press the “Start/Pause
button again.
E20