Filter
Top Products
11
If you select the “Night Cycle” option, the machine
will stop at the end of the programme with the water
still in the tub.
7. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing and the “Washing” and “Door” pilot
lights illuminate and will remain lit.
8. How to change an option or a
programme during its cycle
If the programme has already started, before you make
any change, you must pause the washing machine by
pressing the Start/Pause button.
It is possible to change any option before the
programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme. Turn the
programme selector dial to “O” Off position and then to
the new programme position. Start the new programme
by depressing the Start/Pause button. The washing
water remains in the tub.
Note: To drain the water before starting the new cycle
you have to cancel the programme and select the Drain
programme.
9. How to cancel a programme
during its cycle
Turn the selector dial to “O” Off position to cancel a
programme which is running. Now you can select a new
programme.
10. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
START/
PAUSE
• the level of the water is not high;
If these requirements are met, when you pause the
washing machine, the “Door” pilot light goes off and
the door can be opened.
Should it not be possible to open the door (“Door” pilot
light on), and should it be absolutely necessary to do
so,switch the machine off by turning the selector dial on
Off position.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
After closing the door, select the programme again and
depress the Start/Pause button.
11. End of programme
At the end of the programme, the washing machine
stops automatically and gives an audible signal.
The light of the “Start/Pause” button, the “Door” and
“Washing” pilot lights go off and the light “End cycle”
illuminates. The display will show a flashing zero.
If you had selected the “Rinse Hold”or the “Night
Cycle” option, the corresponding button lights will
be on, the display will show a flashing zero but the
“Door” pilot light will stay on to indicate that the door
is locked and the water must be drained.
To complete the cycle, there are 2 possibilities for
emptying out water:
• turn the selector dial to the “O” Off position and
then select programme “Drain”: the water is
emptied out without spinning.
or
• turn the selector dial to the “O” Off position and
then select programme “Spin”. Select the spin speed
by means of the relevant button and then depress the
Start/Pause button. The water is emptied out and
the laundry is spun at the selected spin speed.
When the programme has been completed the audible
signal is given. Turn the selector dial on Off position to
switch the machine off. Remove the laundry from the
washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket. Leave the door ajar
in order to air the washing machine.