Filter
Top Products
22
Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
Start/Pause button.
If the «Lock» light goes off, the door can be
opened.
If the «Lock» light goes on, this means that the
machine is already heating, that the water level
is above the bottom edge of the door or that
the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After about 3
minutes the door can be opened (pay attention
to the water level and temperature!).
At the end of the programme
The machine stops automatically. The
Start/Pause and «Lock» lights go off, and on
the display will appear a flashing «
0.00». The
door can be opened.
If the «Rinse hold» or «Night Cycle»
option has been selected, the Start/Pause light
is off and «Lock» pilot light illuminates. The
door remains locked to indicate that the water
must be emptied out before opening the door.
The display will show a flashing «
0.00».
To empty out the water please read the steps
on the Rinse Hold option paragraph.
Turn the programme selector dial to «Off» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Operating sequence
132972390.qxd 18/06/2007 14:06 Pagina 22