Filter
Top Products
11
7. Select the “Delay Start”
Before you start the programme, if you wish the
starting to be delayed, press the “Delay Start” button
repeatedly, or keep it pressed, to select the desired delay.
The selected delay time value (up to 24 hours) will
appear on the display for 3 seconds, then the duration of
the programme will appear again.
8. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing and only the light relevant to the phase that
is in progress will remain lit.
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme or
the selected delay.
How to change a programme
during its cycle
You can alter the programme before it starts.
When the programme has started, you can only reset it
by turning the programme selector dial to “Off” and
then you can select the new programme.
Start it by depressing the “Start/Pause” button.
How to interrupt a programme
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash.
Start
Pause
Delay
Start
How to cancel a programme
during its cycle
Turn the selector dial to “Off” to cancel a programme
which is running: three flashing dashes appear on the
display. Now you can select a new programme.
How to open the door during the
cycle of a programme
First set the machine to PAUSE by pressing the
“Start/Pause” button.
If the door does not open, this means that the machine is
already heating or drying, that the water level is above
the bottom edge of the door or that the drum is turning.
During drying the door can be opened only the first 10
minutes and at the end of drying (after the cooling phase).
If you cannot open the door but you need to open it you
have to switch the machine off by turning the
programme selector dial to “Off”.
After about 3 minutes the door can be opened (pay
attention to the water level and temperature!). To restart
depress the “Start/Pause” button.
9. End of the programme
The machine stops automatically.
If the Rinse Hold option has been selected, the light
of the “Start/Pause” button flashes and a static zero
appears on the display to indicate that the water must be
emptied out before opening the door.
The door can only be opened when a flashing zero
appears on the display.
Release of the lock is also indicated by the illumination
of the “End” light.
Turn the programme selector dial to Reset “Off” to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty so as to avoid any forgotten
items being damaged in a subsequent wash (e.g.
shrinking) or their colour running into a load of whites.
If you do not intend to carry out another wash, close the
water tap.
Leave the door open to prevent the formation of mildew
and unpleasant smells.