Filter
Top Products
19
Start the programme by pressing button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing. The appliance starts operating
and the door is locked.
To interrupt a programme which is running,
depress the button : the corresponding
green pilot light starts to flash.
To restart the programme from the point at
which it was interrupted, press the same button
again.
IMPORTANT!
If an incorrect option is selected, the red pilot
light of the button flashes 3 times and the
message Err is displayed for a few seconds.
Altering an option or a running programme
It is possible to change some options before
the programme carries it out.
Before you make any change, you must pause
the washer-dryer by pressing the button .
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «Off» and then to the new
programme position.
Start the new programme by depressing the
button again. The washing water in the tub
will not be emptied out.
Interrupting a programme
Press the button to interrupt a programme
which is running, the corresponding light starts
to flash. Press the same button again to restart
the programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. You can now
select a new programme.
6
6
6
6
6
6
Opening the door after the programme has
started
First set the machine to pause by pressing the
button . The door can be opened
immediately or after a few minutes depending
on the model. In any case do not try to open
the door if it is locked!
If the door remains locked, this means that the
machine is already heating or that the water
level is to high.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After a few
minutes the door can be opened (pay attention
to the water level and temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to press button .
At the end of the programme
The machine stops automatically. Some
acoustic signals sound. The light of button
and the light go off, the light
illuminates and on the display will appear a
flashing «
0.00». The door can be opened.
If, at the end of a programme, there is water in
the tub, the light illuminates but the door
remains locked to indicate that the water must
be emptied out before opening the door.
To empty out the water proceed as follows:
1. turn the programme selector dial to «Off»
2. select the Drain or Spin programme
3. reduce the spin speed if needed, by pressing
the relevant button
4. press the button
5. at the end of programme, only the pilot light
illuminates.
8.3
6
8.3
8.38.1
6
6
6