Filter
Top Products
9
10 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
If you have selected a delay time by means of the
“Delay” button, the countdown will begin and will be
shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
11 “Skip/Reset” button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the “Reset” button must
be pressed once or repeatedly to clear the programme
memory. This will be confirmed by three dashes,
flashing in the display.
If the previous programme is not cleared, the display
will show a flashing “
0”, when you switch the machine
on.
Selecting a special programme:
A wash programme must be selected in the normal way.
(“Start/Pause” button not pressed)
A normal wash cycle consists of the following phases,
Wash - Rinses - Spin and is confirmed by the
illumination of the corresponding LED,s.
Start/Pause
To select rinse & spin, press the “Skip” button once,
the wash LED goes out.
To select spin only, press the “Skip” button twice.
The wash & rinse LED,s go out.
To select Drain press the “Skip” button three times, the
wash - rinse - spin LED,s go out.
If you wish to cancel or advance the running
programme to the required phase, PAUSE the cycle and
then press the “Skip” button as previously described.
Prewash
Wash
Spin
Rinse
Drain
Drying