Filter
Top Products
8
Building-in
This appliance has been designed to be built into
the kitchen furniture.
The recess should have the dimensions shown in
picture A.
Preparation and assembly of the door
The machine is originally pre-arranged for the
assembly of a door opening from right to left.
In this case it is sufficient to screw in the hinges (1)
and the counter-magnet (6) provided with the
appliance, at the right level (Fig. B).
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the
adjacent furniture's base.
b) Hinges
To mount the hinges it is necessary to drill two
holes (dia. 35 mm, depth 12.5-14 mm depending
on the depth of door furniture) on the inner side of
the door. The distance between the holes hobs
fixing centres must be 416 mm.
The distance (B) from upper edge of the door to
the centre of the hole depends on the adjacent
furniture's dimensions.
4
1
2
3
6
1
2
3
P0982
7
8
B
5
P0965
820 min
570 min.
600
596
416
176,5
818
541
195
490
160
120
90
8
515
165
A
600
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of
screws for wood (2-Fig. B) supplied with the
appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means of the
M5x8 screws (3-Fig. B). The hinges can be
adjusted to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to loosen
the screw (3-Fig. B), adjust the door and tighten
the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct operation
of this device, it is necessary to screw the counter-
magnet (6) (steel disk + rubber ring) into the inner
side of the door.
Its position must correspond to the magnet (4) on
the appliance (see picture D).
P0984
6
4
8
D
35 Ø 12.5-14 depth
16-22
B
C
22+1,5
595-598
416
P0422S
C