Filter
Top Products
INSTALLATION
4
Unpacking
Before starting the machine up, the packing must
be removed as follows.
You are advised to keep all the packaging for re-
use in case the machine is to be transported again.
Using a spanner unscrew and remove the rear right
bolt. Lay the machine gently on its back, making
sure that the hoses are not squashed.
Remove the polystyrene base and take off the
bottom panel by unscrewing the central screw.
Carefully slide out the right polythene bag.
Repeat the operation for the left and central
polythene bags.
Re-fit the bottom panel using the 4 screws supplied
with the door hinges (in the plastic bag) and the
previously removed screw.
P0453
P0016
P0015
P0457
P0255
Set the machine upright and remove the two
remaining bolts from the back.
Pull out the three plastic spacers from the holes
into which the bolts were fitted.
Plug the open holes with the plugs which you can
find at the back of the appliance.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Never place cardboard, wood or similar materials
under the machine to compensate for any
unevenness in the floor.
Your new washing machine has been designed to
be permanently plumbed in to your home’s water
supply and drainage system. However, if this is not
possible, it may be connected to suitable existing
taps with the drain hose discharging into a sink.
The appliance has two inlet hoses, hot and cold,
with female 3/4” BSP thread connectors. If this
connection is not compatible with the plumbing of
the existing installation, a variety of connectors are
available from good hardware stores and plumbers
merchants to suit most domestic plumbing. Any
alteration to your existing plumbing must be carried
out by a competent person, or qualified plumber.
Water inlet
The inlets on the back of the appliance are colour
coded, blue for cold and red for hot.
Before connecting the hoses be sure to fit the mesh
filters supplied as per diagram.
P0003
P0020
P0256