Zanussi ZDC 47100 W Clothes Dryer User Manual


 
17
If you are unable to identify or solve the
problem, contact your local Service Centre.
Before telephoning, make a note of the
model, serial number and purchase date of
your machine: the Service Centre will
require this information.
1206
If you call out an engineer to a fault listed
below, or to repair a fault caused by
incorrect use or installation, a charge will be
made even if the appliance is under
guarantee.
Malfunction Possible cause Solution
When pressing a button,
the corresponding
button flashes several
times.
Washing protection.
After the start of the pro-
gramme, the option can no
longer be set.
Turn the programme knob to
OFF. Set the programme again
Drying cycle ends
shortly after programme
starts. END
light illuminated.
Not enough washing
loaded
or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g.
EXTRA DRY instead of CUP-
BOARD).
Programme inactive,
Condenser
light illuminated.
Water reservoir is full.
Empty the water reservoir,
then start programme with
START/PAUSE button.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete“)
Lint filter clogged.
Heat exchanger clogged
with lint.
DELICATE button pressed
and load volume too big.
Load volume too big.
Laundry insufficiently
predrained.
Clean lint filter
Clean heat exchanger.
DELICATE is only suitable for
use with loads of up to 3 kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
Important: