Filter
Top Products
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita-
tion starts, the Cycle Control Knob turns
clockwise until it points to an OFF area and
the cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
WASH
NOTE:
A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the Heavy, Normal, and Perma-
nent Press cycles.
RINSE
M
4
Fill
Fill
Wash selected time
Rinse
Drain (or partial drain*)
No agitation
*The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
l&J
Spin
Drain-No agitation
w
Spin-Spray rinse
&J
Spin
MAGIC CLEAN” lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
MAGIC CLEAN Basket
lint filter
interior
12