Filter
Top Products
8
10. Pull out the Cycle Control Knob to
start the washer.
11. (OPTIONAL STEP) If you select a
Traditional Deep Rinse cycle, you
may add measured and diluted
liquid fabric softener to the final
rinse water. (See page 16.)
IMPORTANT: DO NOT add liquid fabric
softener if you select a Water Saving Spray
Rinse cycle. You could stain your clothes.
Stopping/restarting your washer
• To stop the washer at any time, push in
the Cycle Control Knob.
• To restart the washer, close the lid
(if open) and pull out the Cycle
Control Knob.
Selecting a fabric speed and cycle time
Use the information in this section to help
you make the best cycle selections for your
wash loads. Each cycle is designed for
different types of fabrics and soil levels.
The cycles in the Water Saving Spray
Rinse half of the Cycle Control Knob are
described first. The cycles in the Traditional
Deep Rinse half of the Cycle Control Knob
are described next.
OPERATING YOUR WASHER
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation occurs with
the washer lid up or down.
After agitation starts, the Cycle Control
Knob turns clockwise until it points to an Off
area and the cycle ends.
• Low speed spinning is available only in the
Traditional Deep Rinse cycles.
• A Gentle Wash System helps protect your
fabrics (if Cottons, P. Press, high-speed
agitation is selected) by reducing wash
agitation speed during the last few minutes
of wash agitation in the Super Wash, Heavy,
Regular, and Permanent Press cycles.
• Refer to page 14 to learn more about the
sounds you may hear during a wash cycle.
• Refer to page 11 to help you understand
what happens during the cycles in the
Water Saving Spray Rinse operation of
the washer.
• Refer to page 14 to help you understand
what happens during the cycles in the
Traditional Deep Rinse operation of
the washer.
NOTES:
• The washer pauses briefly throughout each
cycle. These pauses are normal for washer
operation.
• An Extra Rinse option is available in
all cycles.