Filter
Top Products
9
Options
Use these pads to select the desired options for your wash cycle.
Deep Clean
This option provides enhanced cleaning action for tough stains.
The Heavy Duty cycle automatically includes Deep Clean.
Choosing Deep Clean will add approximately 10 minutes to a
c
ycle. Deep Clean should be started on a dry load only and
cannot be selected after the tub has started filling with water.
Deep Clean may be selected as an option with other cycles. See
table for details.
Cycle Deep Clean
(Adds time to the wash cycle)
Whitest Whites Option
Heavy Duty Default
Normal Option
Casual/Perm Press Option
Colors/Darks Option
Delicate Option
Hand Wash/Wool Option
Rinse & Spin Not available
Drain & Spin Not available
Extra Rinse
An extra rinse can be used to aid in the removal of soil, detergent
or bleach residue from garments. This option provides an
additional rinse with the same water temperature as the first rinse.
This is the default rinse setting for the Whitest Whites cycle.
Fabric Softener
If the liquid fabric softener dispenser is used, select the Fabric
Softener option on the console.
Pre Soak (on some models)
Use this option for set-in stains and soil that need extra time for
removal. Soaking in this washer is different than in a conventional
washer. The washer sprays the load with water and detergent for
4 minutes at extra-low spin speed, followed by a soak period. This
allows for the detergent to work on the soils. This is followed by
alternating periods for spray and soak. Using Presoak will extend
your wash cycle by about 14 minutes.
End of Cycle Signal Volume
The End of Cycle Signal produces an audible sound when the
wash cycle is finished. This signal is helpful when you are
removing items from the washer as soon as it stops. Select On or
Off.
Changing Cycles, Modifiers, and Options
You can change Cycles, Modifiers, and Options anytime before
Start is pressed. Not all Modifiers and Options are available for all
cycles.
■ A short tone sounds when a change is selected.
■ Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1. Press PAUSE/CANCEL twice to cancel the cycle. The washer
will drain.
2. Pr
ess POWER.
3. Select the desired wash cycle.
4. Select the desired Modifiers and Options.
5. Pr
ess START.
The washer restarts at the beginning of the new cycle.
NOTE: If
you do not press Start within 5 minutes of pausing the
washer, the washer automatically shuts off.
Changing Modifiers and Options after pressing Start
Options and Modifiers can be changed anytime after Start has
been selected and before the selected Option and Modifier cycle
begins.
NOTE: An e
rror tone will sound if your selection is unavailable.
To manually drain the washer and spin the load
1. Press PAUSE/CANCEL twice to cancel the wash cycle and
drain the washer.
2. Pr
ess POWER.
3. Turn knob to select DRAIN & SPIN.
4. Press START.
When the spin is complete, the lid unlocks. Items can be removed
from the washer.
Normal Sounds
Your new washer may make sounds your old one didn’t. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
If you select the Deep Clean option, you will hear a spin/spray
noise at the start of the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
During wash and spin
This washer does not have a transmission. The motor provides
direct drive for agitation and spin. You will hear sounds that are
different from those of a conventional washer.