Filter
Top Products
7
14. Secure drain hose
16. Install front leveling feet
15. Prepare to install leveling feet
4.5"
(113 mm)
4.5"
(113 mm)
LEVEL WASHER
IMPORTANT: Leveling your washer properly reduces excess
noise and vibration.
Prop up front of washer about 4" (102 mm) with a wood block or
similar object that will support weight of washer. Then screw jam
nut onto each foot to within 1" (25 mm) of foot base.
1"
(25 mm)
Screw feet into threaded holes at front
corners of washer until jam nuts touch washer, but are not tight.
Tilt washer back, remove wood block. Gently lower washer to
oor and slide washer to its nal location. Remove cardboard
used to protect oor.
4.5"
(113 mm)
Laundry Tub Standpipe Wall
Tilt washer forward; self-adjusting rear feet will click into place.
Gently lower washer to oor.
Place a level on top edges of washer, checking each side
and front. Rock washer back and forth to make sure all four
feet make solid contact with oor. If not level, tip washer and
adjust feet up or down, repeating as necessary.
Not Level LEVEL Not Level
18. Check levelness of washer
17. Engage rear leveling feet
Place level here
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with beaded tie strap (A). This will
help reduce the chance of drain water splashing on the oor.
A
A
A