Filter
Top Products
1. Removetheshippingstrapfromthepowercord.Drapethe
powercordovertheconsole.
2. Removeanycardboardusedtomovewasher•
3=
CC>
Beaded tie strap
Wrap the drain hose to the laundry tub leg or drain standpipe
with the beaded tie strap. Push fastener into the nearest hole
in the beaded tie strap. See view A or B.
2=
3=
Screw the Iocknut onto each foot to within 2.5 cm (1") of the
foot base.
2.5 cm
(1")
t
Screw the feet into the threaded holes at the front corner of
the washer until the nuts touch the washer. Twist the feet to
install.
NOTE: Do not tighten the nuts until the washer is level•
B C
If the washer faucets and the drain standpipe are recessed,
put the formed end of the drain hose into the standpipe.
Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
Properly leveling your washer avoids excessive noise and
vibration•
Install the Front Leveling Feet
1. Prop up the front of the washer about 10.2 cm (4") with a
wood block or similar object. The block needs to support the
weight of the washer•
jr
4. Tilt the washer back and remove the wood block• Gently lower
the washer to the floor•
Steps in Final Location
1. Slide the washer to its final location.
2. Tilt the washer forward until the rear of the washer is at least
10.2 cm (4") off the floor• You may hear the self-adjusting rear
feet click into place• Lower the washer to the floor.
3=
A
A. Self-adjusting feet
Check the levelness of the washer by placing a level on the
top edges of the washer, first side to side, then front to back•
A. Threaded holes for feet