Filter
Top Products
Operating Your Washer
In This Section
Page
Page
Bedore starting your washer
-5
..............................
Starting or stopping your
washer
....................
.5
Selecting a load size ..........................................
5
Selecting wash-rinse temperaturss
................
.6
Selecting a cycle and time
.................................
6
Using the SUDS-MlSER’system
....................
.E
Using rinse and spin
........................................
9
Using drain and spin
.......................................
9
What happens in each cycle
.........................
10
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted
load in the washer before starting. See page 12
NOTE:
If your washer has a Consumer Buy
for additional “Before you wash” information.
Guide, remove it and place it in your Use and
Care Guide.
Starting or stopping your washer
l To stop the washer at any time, push in the
Cycle Control Knob.
l To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash.
Select a load size based upon the size of the
load and the fabric you are washing. See
page 12 for additional loading information.
To change the load size setting after the
washer has started to fill, move the Selector to
the desired new setting.