Filter
Top Products
Operating Your Washer
Paw
I
In This Section
Beforo
l
t9rting your wa8her I5 .............................
Sebcting a cycb nd time
..............................
6
Stmrting
or stopping your washw
....................
.5
Using rime nd spin
........................................
6
sobc6ng s load slzo
............................... ..“.- ..
5
Using drain nd spin
.......................................
9
Sobdng
wsshdnso temperaluros
................
.6
What happsns in mch cycb
...........................
9
Operating your washer properly ensures maximum washing efficiency. This section gives you
important information to help you to select
a
cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted
NOTE: If your washer has a Consumer
load in the washer before starting. See page 12
Feature Guide, remove it and place it in your
for additional “Before you wash” information.
Use and Care Guide.
Starting or stopping your washer
Starting your washer:
1. Select a load size and water temperature.
2. Push in and turn the Cycle Control Knob
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time.
3. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopplng and restarting your washer:
*To stop the washer at any time, push in the
Cycle Control Knob.
.To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting a load size
Your washer has a knob or slide Load Size
Selector. Position the Load Size Selector at
the setting that corresponds to the size load
you want to wash.
Select a load size based upon the size of
the load and the fabric you are washing. See
page 12 for additional loading information.
l If your washer has a knob Load Size Selec-
tor,
turn selector to
the desired load size.
Smtting mmy v8ry with &
5