Filter
Top Products
Operating Your Washer
I
In This Section
Before stating your wuher
.............................. 5
Selecting a cycle and
time
.............................
.6
Starting
or stopping
your
waahw
....................
.5
Using rinse nd
l
ptn
.......................................
.6
Meeting a load size
.......................................... 5
Uoing drain and spin
.......................................
6
Selecting
wash-rinse temperatures
................
.6
What happen. in each
cyck
..........................
.9
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a
sorted load in the washer before starting.
See page 11 for additional “Before you wash”
information.
NOTE: If your washer has a Consumer Buy
Guide, remove it and place it with your Use
and Care Guide.
Starting or stopping your washer
Starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in
the wash cycle you want. The numbers are
minutes of wash time.
2. Select a load size and a water temperature.
3. Pull out the Cycle Control Knob.
Stopplng and rsstartlng your washer:
l To stop the washer at any time, push in the
Cycle Control Knob.
l To restart the washer, close the lid (if
necessary) and pull out the Cycle Control
Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash.
Select a load size based upon the size of
the load and the fabric you are washing. See
page 11 for additional loading information.
To change the load size setting after the
washer has started to fill, move the Selector to
the desired new setting.
5