Whirlpool 7LSC9245BN0R Washer User Manual


 
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately
after
filling; agitation can occur
with the washer lid up or down. After agita-
tion starts, the Cycle Control Knob turns
clockwise until it points to an OFF area and
the cycle ends.
The washer pauses briefly throughout
each cycle. These pauses
are normal for
washer operation.
NOTE: The
Gentle Wash System helps
protect your fabrics (ii high-speed agitation is
selected) by reducing wash agitation speed
during the last few minutes of wash agitation
in the Heavy, Regular, and Permanent
Press cycles.
WASH
Fill
t
kl
Wash selected time’
‘If high-speed agitation is selected, agitation
speed is reduced in the last few minutes of
most cycles. This provides better fabric care.
RINSE
Rinse
L4
-+- Drain-No agitation
Drain (or partial drain*)
No agitation
w
Spin-Spray rinse
‘The Permanent Press cyde partially
drains, fills, agitates briefly, and drains.
Spin
Spin
MAGIC CLEAN’ lint filter
The lint fiiter at the bottom of the washer
basket cleans itseif. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the fitter and out of the
system during the spin part of the cycle.
if your washer drains into a tub, remove
any lint collected in the tub or strainer.
MAGIC CLEAN Basket
lint filter
interior
12