Filter
Top Products
If you need service or assistance, we suggest
you follow these four steps:
1, Before calling for
assistance...
Performance problems often result
from little things you can find and fix
yourself without tools of any kind.
If your washer does not fill:
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Are both water faucets open?
l
Have you checked your home’s
main fuses or circuit breaker box?
l
Are the water supply hoses kinked?
l
Is the Cycle Control Knob set and
pulled out?
If your washer does not spin:
l
Is the lid closed?
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Have you checked your home’s
main fuses or circuit breaker box?
If your washer drains at the wrong
time:
l
The drain hose should be at least 28
inches above the floor and secured.
l
The drain hose should not fit tight-
ly in the drain pipe.
18
l
Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Make sure the drain hose is higher
than the water level in the washer. If
it isn’t...
l
The washer may seem to be drain-
ing during wash and rinse cycles.
l
Water can siphon out. (See “lnstalla-
tion Instructions:‘)
If your washer stops during the per-
manent press cycle:
l
Remember, the washer will stop for
about 2 minutes after the partial
drain during the cool-down period
in this cycle.
If your dryer does not run or heat:
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Is the door closed tightly?
l
Did you push START?
l
Have you checked your home’s main
fuses or circuit breaker box?
l
The AIR setting is without heat.
l
The last minutes of heat settings
are without heat. See page 12.
If drying times seem too long:
l
Is the lint screen clean?
l
Is the room cold?
l
See page 14 of this book and page
19 of your “Laundry Guide:’