Filter
Top Products
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily solled loads which
need more detergent. (Extra de-
tergent can require an extra rrnse )
l
Push Control Knob In
9 Turn clockwrse to any.on the dial
See above drawing.
l
Pull Control Knob out
l
The washer will fill to selected
level; agrtate 2 mrnutes, drain
and spin
For a drain and spin
Your washer can be set to dram
and spin out water
. Push Control Knob in
. Turn clockwrse to the bar just before
OFF See above drawing.
l
Pull Control Knob out.
. The washer will dram and spin
for agitation and spin speeds in each cycle, see pages 8 and 9
For a soak or prewash
For best results, use
warm Water
for soaking or pre-washing stained
laundry
Hot water can Set
Stains.
.
.
.
.
.
Use recommended amount of
detergent or pre-soak product.
Push Control Knob in.
Turn clockwrse to point at a number
in the SOAK Cycle?
Pull Control Knob out to start washer.
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
intormation on page 7 of your
“Laundry Guide!’
‘To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.