If you need service or assistance,
we suggest you follow these four steps:
I. Before calling for assistance.. .
Performance problems often re-
sult from little things you can find
and IIX yourself without tools of any kind
IF YOUR WASHER DOES NOT FILL:
l
Is the power supply cord
plugged in?
l
Are both waler faucets open?
l
Are fuses blown or clrcult-breaker
tnpped?
l
Are the water supply hoses klnked?
l
Is the Cycle Control Knob se! and
pulled out?
IF YOUR WASHER DOES NOT SPIN:
l
Is the lid closed?
l
Is the power supply cord plugged in?
l
Are fuses blown or a circuit-breaker
tripped?
IF WASHER DRAINS AT THE WRONG TIME:
l
The drain hose should be at least
28 inches above the floor and
secured.
l
The drain hose should not fit tightly
in the drain pipe.
MAKE SURE THE DRAIN HOSE IS
HIGHER THAN THE WATER LEVEL IN
THE WASHER. IF IT ISN’T...
l
The washer may seem to be
draining during wash and rinse
cycles.
l
Water can siphon out (See “ln-
stallation Instructions”]
IF YOUR WASHER STOPS DURING
THE PERMANENT PRESS CYCLE:
l
Remember,the washer will stop
for about 1’ z minutes after the
partial drain during the cool-
down period in this cycle
DRYER DOESN’T RUN OR
DOESN’T HEAT:
l
Is it plugged in?
l
Is the circuit-breaker tripped or
one or both of the fuses blown?
l
Did you push START?
l
Is the door closed?
l
The AIR setting is without heat.
l
The last minutes of heat settings
are without heat. See page 12.
DRYING TIME SEEMS LONG:
l
Is the lint screen Clean?
l
Is the room cold?
l
Check your”Laundry Guide:’
page 19.