Filter
Top Products
Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIRE HAZARD.
The lint screen is
2. Lightly
4-y
inside the dryer putt
squeeze the
drum, on the
straight
body, as
back wall.
shown, while
1. Use the finger
pulling the
holes to pull
cover off.
‘\
the lint screen
3. Roll lint off the
/
\
straight out.
screen with
your fingers.
WARNING: DO NOT run the
Squeeze body;
DO NOT rinse
pull cover off.
dryer with the lint screen
or wash the
base, damaged or missing.
screen. Wet lint is hard to remove.
Doing so can cause over-
heating, can damage fabrics and
1
4. Replace the cover on the body of
the lint screen.
can be a FIRE HAZARD.
5. Push the lint screen straight back
in until it clicks into place
Lint removal
Lint can gather inside the dryer and create a fire hazard.
This lint should be removed every 2 to 3 years, or more often,
depending on dryer usage.
Cleaning should be done only by a qualified service person.
1. Remove back panel from dryer
2. Avoid touching thermostats,
wires, terminals and heater box.
3. Remove lint from shaded area
- see art - with a sol? brush or
vacuum cleaner,
4. Replace back panel. Recon-
nect, exhaust duct, etc.
Level the washer/dryer.
l
Avoid electrlcal shock
hazard- unplug power
supply cord or turn off
electrical power.
l
Avoid injury or damage-do not
put hands inside cabinet.
l
Metal edges may be sharp.
l
Make sure dryer is cool.
Exhaust Duct Outlet