Filter
Top Products
Lint screen
Clean the lint screen before each load. A screen b
increase drying time and may be a FIRE HAZARD.
The lint screen is
inside the dryer p
drum, on the
stra
back wall.
0
1. Use the finger
holes to pull
the lint screen
straight out.
2. Lightly
squeeze the
body, as
shown, while
pulling the
cover off.
3. Roll lint off the
screen with
‘locked by lint can
0
WARNING: DO NOT run the
dryer with the lint screen
loose, damaged or missing.
Doing so can cause over-
heating, can damage fabrics and
can be a FIRE HAZARD.
your fingers.
Squeeze body;
DO NOT rinse
pull cover off.
or wash the
screen. Wet lint is hard to remove.
4. Replace the cover on the body of
the lint screen.
5. Push the lint screen straight back
in until it clicks into place.
Lint removal
Lint can gather inside the dryer and create a fire hazard.
This lint should be removed every 2 to 3 years, or more otten,
dependlng on dryer usage.
Cleaning should be done only by a qualified service person.
1. Remove back panel from dryer,
2. Avoid touching thermostats,
Thermostats
wires, terminals and heater box.
3. Remove lint from shaded area
- see art - with a soft brush or
vacuum cleaner.
4. Replace back panel. Recon-
nect , exhaust duct, etc.
Level the washer/dryer.
a
l
Avold electrical shock
hazard-unplug power
supply cord or turn off
electrlcal power.
l
Avoid injury or damage-do not
put hands Inside cabinet.
l
Metal edges may be sharp.
l
Make sure dryer is cool.
Heat Element Terminals
14