Filter
Top Products
If you need setice or assistance,
we suggest you follow these five steps:
1, Before calling
assistance...
for
If your washer drains at the wrong
time:
l
The drain hose should be at least 28
inches above the floor and secured.
l
The drain hose should not fit tight-
ly in the drain pipe.
l
Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Performance problems often result
from little things you can find and fix
yourself without tools of any kind.
If your washer does not fill:
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Are both water faucets open?
l
Have you checked your home’s
main fuses or circuit breaker box?
l
Are the water supply hoses kinked?
l
Is the Cycle Control Knob set and
pulled out?
l
Is Selector Switch set in the WASHER
position?
If your washer does not spin:
l
Is the lid closed?
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Have you checked your home’s
main fuses or circuit breaker box?
If drying flmes seem too long:
l
Is the lintscreen clean? See page 17
of this book for cleaning instructions.
l
See page 16 of this book and your
“Laundry Guide!’
Make sure the drain hose is higher
than the wafer level in the washer. If
if isn’t...
l
The washer may seem to be drain-
ing during wash and rinse cycles.
. Water can siphon out. (See “lnstalla-
tion Instructions:‘]
If your washer stops during the per-
manent press cycle:
l
Remember, the washer will stop for
about 2 minutes after the partial
drain during the cool-down period
in this cycle.
If your dryer does not run or heat:
l
Is the power supply cord plugged
into a live circuit with the proper
voltage?
l
Is the door closed tightly?
l
Did you push START?
l
Have you checked your home’s
main fuses or circuit breaker box?
l
The AIR setting is without heat.
l
The last minutes of heat settings
are wlthout heat. See page14.
l
Is Selector Switch set in the DRYER
position?
20