Filter
Top Products
Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIRE HAZARD.
inside the dryer pI
drum, on the
strai
back wall.
01
1. Use the finger
holes to pull
the lint screen
straight out.
-
The lint screen is
inside the dryer pull
drum, on the
straight
back wall.
1. Use the finger
the lint screen
2. Lightly
squeeze the
body, as
shown, while
pulling the
cover of-f.
3. Roll lint off the
screen with
your fingers. your finaers.
s
DO NOT rinse
pull cover off.
or wash the
screen. Wet lint is hard to remove.
4. Replace the cover on the body of
the lint screen.
5. Push the lint screen straight back
in until it clicks info place.
Sbueeze badv:
in until it clicks info place.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. This lint
should be removed at least every 2 to 3 years, or more often, depending
on dryer usage.
Cleaning should be done only by a qualified person.
1. Remove back panel from dryer.
2. Avoid touching thermostats,
wires, terminals and heater box.
3. Remove lint from shaded area
-
see art - with a soft brush or
vacuum cleaner.
4. Replace back panel. Recon-
neCt, exhaust duct, etc.
Level the washer/ dryer.
Thermostats
Heaty,Box
Heat Element Terminals