Filter
Top Products
Starting your
dryer and
selecting a cycle
Before starting your dryer, be
sure laundry IS sorted and loaded
properly [see your”Dryer Guide”)
Be sure the door is tightly closed.
1
Turn
. power on
Touch FABRIC-TEMP
2.
Selector
Move the POWER SWITCH up.
You will have 8 seconds to touch
a FABRIC-TEMP Selector.
Within 8 seconds, touch the lower
part of a FABRIC-TEMP Selector. The
dryer will not operate if you touch the
upper half of the selector.
You may change the dryer setting
at any time during any cycle by
touching the desired selector or
selectors.
Touch a CUSTOM DRY
3. or TIMED DRY Control
IMPORTANT: If you do not touch a
CUSTOM DRY or TIMED DRY Control,
the dryer will automatically select
NORMAL DRY.
If this is not the dryness you like,
you must touch one
of
the other
dryness Controls. See page 6 of this
book for more details.
4
l
To stop the dryer
1.
Open the door, or...
2. Move POWER SWITCH to OFF
l
To check the load
1. Open door.
2. The dryer will remember where it
was in the cycle if you restart the
dryer within 2 minutes. Touch
selector with the blinking light to
restart.