Filter
Top Products
2. Measure Detergent; Add to
Washer Basket.
l
See detergent information on page
6 and in Section IV of the Laundry
Guide.
l
Add dry bleach or water condi-
tioner [not fabric softener) if used.
Follow the package directions
carefully.
3. Dilute liquid Bleach Before Add-
ing to the Washer Basket.
l
See the “Laundry Aids” section of
the Laundry Guide for more
information.
4. load the Washer.
l
Spread the load evenly. (Don’t put
all the towels on one side and a few
wash cloths on the other.) An unbal-
anced load can cause the washer to
shake during spinning.
l
Load without packing so items can
move freely for best cleaning and
least wrinkling.
5. Add Diluted Fabric Softener Only
to the Deep Rinse Cycle.
. DO NOT ADD FABRIC SOFTENER TO
THE WASH. Fabric softeners can com-
bine with soap or detergent to make
greasy stains on fabrics.
Understanding
your Washer .
This portable compact washer
may be different from ones you hove
used before It rolls back and forth on
casters and hooks to a faucet. You con
trol the wash and r:nse temperatures
by controlling the temperature of water
from the faucet
This L&e anti Core &de suggests
temperature settings, load sizes and
detergent amounts It shows ,what the
washer does In each cycle, and when
to change the water temperatures for
best washing results
Moving the Washer:
The lwasher rests or1 casters The
casters will allow ine washer to move
back and forth, but not from srde to
side Thts helps keep the Nasher from
moving while it IS rurin\rlg
Using the \yosher #orI a level floor
WIII help reduce vlbratior and move-
ment during sprnn rg
Connecting the Washer:
l
Pull the hoses out of their storage area
In the back of the washer.
l
Attach the hose connector to the
faucet adapter by pullrng down on the
lockrng collar and lrftrng up on the con-
nector until It snaps Into place Release
the locking collar
Water Flow Button
l
Slowly
turn the water faucet on to full
If your sink has a spray hose. it should
be disconnected or replaced with a
hrgh pressure hose. Water pressure can
break a standard spray hose
l
Pull the electric power supply cord
from Its storage areu In the buck of the
washer
l
Plug the cord into a grounded outlet.
See Installation Instructions for proper
outlet and complete rnformatron
Disconnecting the Washer:
l
Unplug the electric power supply cord
and put it back in its storage area
l
Turn the water faucet off
l
Press the red Water Flow Button tc
empty water pressure from the hose
l
Move the locking collur down and
pull down on the connector
l
Drain OS much water as you can from
the hoses through the faucet connector
l
Push the hoses back into iheIr storage
area