Filter
Top Products
For a Pre Wash
Use this settrnli for a sh#orter SOAK
CYCLE (no rinse] Use enough1 detergent
for a single wash. Add the load.
l
Set the
LOAD SIZE SELECTOR.
l
Set wash water temperature
tf you want high agitation and a
high-speed sprn. use the dot In REGU-
LAR HEAVY. If you want low agrtation
and a low-speed spin, use the dot In
KNITS GENTLE Use the dot in PERMA-
NENT PRESS If you want high agrtation
and a low-speed spin.
For Spinning Only
l
Push the Cycle Control Knob in and
turn It to the 12.minute mark rn the SOAK
CYCLE
l
Pull the Control Kr ob out tc start the
washer
l
The washer will fill agitate for two
minutes, soak for eight minutes, agitate
for two more, and then drain and spin
l
After filling, the washer may pause
before starting to agitate.
For Rinsing Only
Loads with towels, diapers, jeans
or heavily sorled Items often need extra
detergent Extradetergentcanrequire
an extra rinse
Your washer can be set to rinse
only. Use the setting for an extra rinse, or
for laundry that only needs a rinse and
There may be times when you
want to drain out all the wash water and
start over. To stop the washer
at
any
time, just push In on the Cycle Control
Knob.
To set the washer so it drains and
spins water out of the load, push in on
the Control Knob, turn the dial to the
right (clockwrse) so the pointer is touch-
ing the bar just before OFF in any cycle.
The washer will drain, spin out
water and stop. If you want a low-speed
spin, use the bar on PERMANENT PRESS
or KNITS GENTLE. All the other cycle
settrngs have a high-speed spin
There
IS
o dot just after the num-
bers in PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE If you push in
on the Cycle Control Knob, turn the
pointer to one of those dots and pull the
Control Knob out. the washer will fill,
agitate, drain and spin.