Filter
Top Products
Select WASH and
4.
RINSE OPTIONS
A.
The Electronic Controls are pre-
set for a warm wash and cold rinse
in every FABRIC selection.
6. Change wash and rinse tem-
peratures by touching WASH OPTION
gelectors.
l
You must touch an OPTION within 8
seconds after touching a FABRIC
selection.
l
See page 10 for more tips
on adding OPTIONS to FABRIC
selections.
5
Restarting
. your washer
Your washer will “remember” its
cycle if you touch HOLD. It will not
remember if there is a power
interruption such as a blown fuse.
If memory is lost at beginning
of wash cycle -
1. Move switch to POWER ON.
2. Touch FABRIC selector and
options.
3. The washer will finish filling [if
needed) and wash according
to the new selections.
It memory is lost at end of
wash cycle -
1. Move switch to POWER ON.
2. Touch SPIN ONLY to drain and spin
3. After the washer stops, again
move switch to POWER ON.
4. Touch RINSE SPIN to fill, rinse, drain
and spin the load.
If memory is lost at beginning
of rinse cycle -
1. Move switch to POWER ON.
2. Touch RINSE SPIN to finish filling or
to finish the rinsing cycle.
6