Filter
Top Products
. SET LOAD SIZE
l
SET WATER TEMPERATURE
. PUSH IN KNOB, TURN TO
CYCLE AND TIME
. PULL OUT TO START
SOAK CYCLE
‘III? cbc~e IS riot for washing rt soaks
ag totes splhs out the water and stops
-IC r nse I ;Ise It for starned yellowed
grew or neoL#rly sorled laundry with a
de’ergent or pre-soak product Chlorrne
bleach f uanted should be added
t? the cycle LOL use after the SOAK
&Ye IS ‘over
If You Need
Service or Help,
We suggest You
Follow These Three
Steps:
1 Before calling for service ,..
Prot3ems I-- j:li‘ietrrnes causec
t,, ‘lf’c? +mgs yc 1
.ar’ .:orrect without
t I,‘15
d
Check this 15’ beUs you
call
for
set ~172
IF YOUR WASHER DOES NOT FILL:
l
Is tie power su;~o ;/ cord plugged
in:
l
Are both water +oucets open?
l
1s c fuse blowr or fcrrcurttbreaker
triproe
10
l
Are the water supply hoses kinked7
l
Is the Cycle Control Knob set and
pulled out?
l
Are the water inlet hose filter screens
clean?
To check the screens’
~ Turn off the faucets.
~ Remove hoses and check the
screens
- Clean the screens under runntng
water
- Replace the hoses and ttghten
connections.
~ Turn on the faucets and check
the leaks
IF YOUR WASHER DOES NOT SPIN:
l
Is the lid closed?
l
Is the power supply cord plugged In7
l
Is a fuse blown or crrcuit-breaker
tripped’
IF WASHER FILLS AND DRAINS WITHOUT
RUNNING:
l
Make sure that the Cycle Control
Knob IS pointing to a number tn the cycle.
IF YOUR WASHER STOPS DURING THE
PERMANENT PRESS CYCLE.
l
Remember, the washer WIII stop for
about 1% minutes after the p&cl drain
durtng the cool-down pertod tn this
cycle.
MAKE SURE THE DRAIN HOSE IS HIGHER
THAN THE WATER LEVEL IN THE WASHER.
IF IT ISN’T...
l
The washer may seem to be draining
during wash and rinse cycles.
l
Water can siphon out (See Installation
Instructions ]