Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l
Push Control Knob in
. Turn clockwise to any
l
on the dial
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected level
with cold water, agitate 2 minutes,
drain and spin.
For a drain and spin
Your washer can be set to drain
and spin out water
l
Push Control Knob In.
l
Turn clockwise to the bar lust before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6-9.
/
me-wash
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry
9 Use enough detergent or pre-soak
product for a single load.
l
Push Control Knob in
l
Turn clockwise to point at a number
in the SOAK Cycle.*
l
Pull Control Knob outto start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide!’
l
Set the washer and start the next
selected wash cycle.
*To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the Cycle.
10