Filter
Top Products
Starting your washer
Betore starting your washer:
1. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
Select a
1. LOAD SIZE
Select CYCLE and
WATER TEMPERATURE;
2. Start the washer
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or
between small (a few items) and
large (a full load].
NOTE: Use the LARGE water level
for best permanent press results.
LOAD SIZES AND
WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
CAUTION:
DO NOT
OVERLOAD WASHER.
(17.2 ;%%I L)’
SMALL
(9.5 gals./36.0 L)’
*Approximate
fill with load.
A.
Push In the Control Knob and
turn It to the right. It must be
pushed in and turned only
clockwise.
B.
To select wash water temperature,
stop on the area in the selected
cycle marked H (hot], W (warm)
or C (cold].
Match the wash water tem-
perature to the type of fabrics
and soils being washed.
Recommended wash tem-
peratures can be found in your
“Laundry Guide!’
All rinses are cold. Cold rinses
save energy and help prevent
wrinkles from setting into fabrics.
4