Filter
Top Products
2 - 1
Optional Pedestal
A pedestal may be purchased separately for this
washer. This pedestal will add about 14 inches to the
height of your unit for a total vertical height of approxi-
mately 52 inches (132 cm).
Optional Pedestal
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer
“walk.”
Your washer can be installed under a custom counter,
or in a basement, laundry room, closet, or recessed
area. (See “Drain System.”)
Companion appliance location requirements should
also be considered. Proper installation is your respon-
sibility.
You will need
• A water heater set to deliver 120°F (49°C) water
to the washer.
• A grounded electrical outlet located within 5 ft.
(1.5 m) of where the power cord is attached to the
back of the washer. (See “Electrical Require-
ments.”)
• Hot and cold water faucets located within 4 ft.
(1.2 m) of the hot and cold water fill valves, and
water pressure of 20-100 psi (137.9-689.6 kPa).
• A level floor with a maximum slope of 1 in.
(2.5 cm) under entire washer. Installing the washer
on carpeting is not recommended.
• A sturdy and solid floor to support the washer with
a total weight (water and load) of 400 lbs. (180
kg).
Do not operate your washer in temperatures below
32°F (0°C). Some water can remain in the washer and
can cause damage in low temperatures.
INSTALLATION INFORMATION
INSTALLATION
REQUIREMENTS
Tools and Parts
Assemble the necessary tools and supplies before be-
ginning the washer installation. The parts supplied are
in the washer basket.
Tools needed for connecting the water inlet hoses
• Pliers (that open to 1 9/16 in.)
• Flashlight (optional)
Tools needed for installation
• Open end wrench 5/8 in. (17 mm) and ½ in. (13
mm)
• Level
• Wood block (2" x 4")
• Ruler or measuring tape
Parts supplied:
If You Have
Laundry tub or
standpipe taller
than 96 in. (2.4 m)
Overhead sewer
Floor drain
Drain hose too short
Water faucets beyond
reach of fill hoses
You Will Need to Buy
Sump pump system (if not al-
ready available)
Standard 20 gal. (76 L), 30 in.
(76.2 cm) tall drain tub or util-
ity sink and sump pump (avail-
able from local plumbing sup-
pliers)
Siphon break, Part Number
285834; additional drain hose
Part Number 8318155; and
connector kit, Part Number
285835
Drain hose extension kit, Part
Number 285863
2 longer water fill hoses:
6 ft. (1.8 m) Part Number
76314, 10 ft. (3.0 m) Part Num-
ber 350008
Alternate Parts You May Need
Beaded strap
Transport Bolt Hole
Plug (4)