Filter
Top Products
6 - 11
POSSIBLE CAUSE/TEST
Note: Possible Cause/Tests MUST be performed in the sequence
shown for each problem.
1. Verify the unit is level.
2. Check pump drain system – this could indicate a failure to drain.
3. Check Operating Pressure Switch.
4. Check Pressure Switch hose.
5. Check Flow Meter operation.
6. Check the CCU.
1. Check Drive belt.
2. Check Drive motor.
3. Check Wire Harness connections.
4. Check Motor Control Unit.
1. Check Drive motor.
2. Check Wire Harness connections.
3. Check Drive belt.
4. Check Motor Control Unit.
1. Check Wire Harness connections.
2. Check Drain pump.
3. Check Drain pump motor.
4. Check that the Drain hose and Drain Pump Filter is clear of
foreign objects.
5. Check the CCU.
1. Remove Shipping system.
2. Check installation.
3. Check leveling feet.
4. Check leveling feet lock nuts.
5. Check for weak floor.
1. Check that the Inlet Hoses are connected properly.
2. Check the Water Heater and Wire Harness connections to it.
3. Check Water Temperature Sensor for an abnormal condition.
4. Check the CCU.
PROBLEM
OVER FILLS
BASKET WON’T ROTATE
MOTOR OVERHEATS
WON’T DRAIN
MACHINE VIBRATES
INCORRECT WATER
TEMPERATURE