Whirlpool LER5848DQ0 Clothes Dryer User Manual


 
Selecting the right cycle and setting
The following pages describe the cycles on
your dryer. Refer to the charts on pages 9-l 0
for help in selecting drying cycles.
Drying guidelines
l Always follow care label directions when
l Overdrying can cause shrinkage, static
they are available.
cling, and damage to some fabrics.
l Use the Fluff Air cycle, or line dry rubber,
l Refer to pages 17-20 for information
plastic, delicate, and heat-sensitive fabrics
about:
(see page 10).
-sorting clothes for drying
l The last few minutes of all cycles are without
heat to make the load easier to handle.
_
choosing
load sizes
l To help reduce wrinkling, remove the load
- drying tips
from the dryer as soon as tumbling stops.
_ using dryer fabric softeners
This is especially important for permanent
- saving energy
press, knits, and synthetic fabrics.
- drying special-care items.
Your easy-to-use dryer has a color-coordi-
nated Cycle Control Knob and Fabric/
Temperature Selector. When using the
automatic cycles, simply choose the setting
on the Cycle Control Knob that corresponds
with the one you chose on the Fabric/Temp
Selector. When using Timed Drying, choose
High, Medium, or Low heat with the Fabric/
Temp selector. (See chart on page 9.)
Automatic Cycle(s)
Your dryer has five Automatic cycles (Heavy,
Normal, Wrinkle Resist, Quick Dry, and
Delicate) and three corresponding tempera-
ture selections. All of the Automatic cycles
use an Electronic Sensor Dry control that
senses the amount of moisture in the load.
FabticlTemp
Your Automatic cycle(s) shuts off when the
selected dryness is reached. The Cycle
Control Knob will not move until the load is
almost dry. After the cool-down and the
FINISH GUARD@ portion of the cycle (if
selected), the Knob automatically turns to an
OFF area and tumbling stops.
l If the load is drier than you like, select a
setting closer to LESS DRY the next time
you dry a similar load.
l If the load is not as dry as you like, com-
plete drying using the Timed Drying cycle.
Select a setting closer to VERY DRY the
next time you dry a similar load.
7